226
Using File Memory Section 5-3
When the Power Supply Switch is pressed, the MCPWR Indicator will flash
once, light during the compare operation, and then go OFF if the compare
is completed normally and the data is the same.
Note Confirm that the Units and Boards are running properly before attempting the
above operations. The write, read, and compare operations will not be per-
formed unless the Units and Boards are running properly.
5-3 Using File Memory
5-3-1 Initializing Media
Memory Cards
1,2,3... 1. Use a Programming Device, such as a Programming Console, to initialize
Memory Cards.
EM File Memory
1,2,3... 1. Use a Programming Device like a Programming Console and set EM file
memory settings in the PLC Setup to enable EM file memory, and then set
the specified bank number for EM file memory to 0 to C Hex.
2. Use a FINS command or a Programming Device other than a Program-
ming Console to initialize EM file memory.
Initializing Individual EM
File Memory
A specified EM bank can be converted from ordinary EM to file memory.
Note The maximum bank number for CJ-series CPU Units is 6.
CX-Programmer
Or
Programming
Console
Memory Card
CX-Programmer
Or
Programming
Console
Specify the starting
bank number for
EM file memory.
Initialize EM file memory.
CX-Programmer
Or
Programming
Console
To Next Page
Loading...
Need help?
General
