Omron V680-CA5D01-V2 User Manual

5
RFID System
User's Manual
Introduction
Introduction
Always observe the following precautions to prevent operation failure, malfunctions, and adverse effects on
performance and equipment.
1. Installation Environment
Do not use the Product in the following locations.
• Locations exposed to corrosive gases, dust, metallic powder, or salts
• Locations not within the specified operating temperature range
• Locations subject to rapid changes in temperature or condensation
• Locations not within the specified operating humidity range
• Locations subject to direct vibration or shock outside the specified ranges
• Locations subject to spray of water, oil, or chemicals
2. Installation
• This Product uses a frequency band of 13.56 MHz to communicate with ID Tags. Some transceivers,
motors, inverters, switching power supplies, etc., generate electrical noise that will affect these com-
munications. If any of these devices are located in the vicinity of the Product, they may affect commu-
nications with ID Tags, and may possibly damage the ID Tags. Prior to using the Product in the
vicinity of any of these devices, perform a test to determine whether the Product can be used under
the resulting influence.
• Observe the following precautions to minimize the effects of normal noise.
(1)
Ground the ground terminal on the Product and all metal objects in the vicinity of the Product to
100 Ω or less.
(2) Do not use the Product near high-voltage or high-current lines.
• The Product is not waterproof. Do not use it in an environment where mist is present.
• Do not expose the Product to chemicals that adversely affect the Product materials.
• Use a tightening torque of 1.2 N·m max.
• If multiple Antennas are mounted near each other, communications performance may decrease due
to mutual interference. Refer to Installing Antennas in the V680 Series User's Manual for Amplifiers,
Antennas, and ID Tags (Cat. No. Z262, Z248)
and check to make sure there is no mutual
interference.
3. Storage
Do not store the Product in the following locations.
• Locations exposed to corrosive gases, dust, metallic powder, or salts
• Locations not within the specified operating temperature range
• Locations subject to rapid changes in temperature or condensation
• Locations not within the specified storage humidity range
• Locations subject to direct vibration or shock outside the specified ranges
• Locations subject to spray of water, oil, or chemicals
4. Cleaning
• Do not clean the Product with paint thinner, benzene, acetone, or kerosene. These chemicals will dis-
solve the resin materials and case coating.
Precautions for Correct Use

Omron V680-CA5D01-V2 Specifications

General

Brand	Omron
Model	V680-CA5D01-V2
Category	Controller
Language	English