2-5
Fault Screen
If a fault shutdown occurs the ALARM status lamp
will blink and the LCD screen will display the Fault
Number, a description of the Fault and the hour in
total genset running time when the Fault occurred
(Figure 2-4). Refer to TABLE 9-1. TROUBLE-
SHOOTING GENSET FAULTS to diagnose and
correct the problem.
The e-Series Digital Display will display the fault in-
definitely. Touch any button to clear the fault. The
display will turn off in 5 minutes after the fault has
been cleared.
Press [
BACK] to go back to the GEN STATUS
screen.
FIGURE 2-4. TYPICAL FAULT SCREEN
Redistribution or publication of this document,
by any means, is strictly prohibited.
To Next Page
Loading...
Need help?
General
