EN-2
1-5
INSTALLATION WORK FLOWCHART
1-4
DETECTION AREA
1-3
PARTS IDENTIFICATION
Clean the laser window using a damp cloth.
A smeared laser window can limit the detection area due to
the reduced laser sensitivity. In addition, heavy soiling of the
window can induce detection errors.
Cleaning the Product
Laser window
This product is categorized as a Class 1 product in terms of the Safety
Standard.
Average Power : Max. 0.021 mW (AEL)
Wavelength : 905 nm
Pulse Width : 4 ns
Emission period : 35 μs
Standard : IEC 60825-1
Class 1 of the Laser Safety Standard means that the safety of laser products
belonging to this class is warranted under normal operating conditions
(reasonably predictable operating conditions). The product is marked to indicate
that it is laser equipment. No additional safety measures are necessary.
Complies with 21 CFR 1040.10 and 1040.11 except for deviations pursuant to
Laser Notice No.50, dated June 24, 2007.
Class 1 laser product
Do not expose your eyes directly to the laser beam
On Safety of Laser
Warning: This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures. (EN 55032)
CE Statement
Walk-test and confirm
the detection area.
(Refer to 4-3)
Change the assembly option according
to the mounting type. (Refer to 2-2, 2-3)
Mounting and angle adjustment.
(Refer to 4 )
Wiring and Power On
(Refer to 5 )
Laser area confirmation
(Refer to 4-3)
Area setting (Refer to 6 )
Configuration
Completion
OK
OK
NG
NG
Choose the detection area mode and
installation location. (Refer to 2-1)
X
Y
Side view Front view
20 m max.
20 m max.
Approx.
400 mm
To Next Page
Loading...
Need help?
General
