Servicing Batteries
A single battery is installed in each SP and SPP in the server.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail. Follow antistatic precautions to
prevent electrostatic damage. See “Prevent ESD Damage” on page 61.
These topics explain how to service batteries in the server.
Step Description Links
1. Remove the SP or SPP so that you can replace the
battery.
“Servicing SPs” on page 117
2. Replace the battery. “Remove the Battery” on page 247
“Install the Battery” on page 250
3. Install the SP or SPP after you have replaced the
battery.
“Install an SP or SPP” on page 136
Related Information
■
“Identifying Components” on page 15
■
“Detecting and Managing Faults” on page 35
■
“Preparing for Service” on page 57
■
“Controlling the Server and Domains” on page 67
■
“Understanding Server Configurations and Failover Behavior” on page 79
Remove the Battery
This procedure can be performed only by qualified service personnel after removing the SP
or SPP that contains it. You do not need to power down the server before performing this
procedure, but you do need to ensure that the SP or SPP that you remove is not the managing
system or DCU activity.
Servicing Batteries 247
To Next Page
Loading...
Need help?
General