Prepare a CMIOU for Removal
Related Information
■
“Servicing PDECBs” on page 199
■
“Checking for Faults” on page 35
■
“Interpreting LEDs” on page 44
Prepare a CMIOU for Removal
This procedure can be performed by a customer while the server is running.
Replace a CMIOU when the replacement CMIOU is available.
Complete the following steps before you unseat or remove a CMIOU.
Caution - This procedure requires that you handle components that are sensitive to electrostatic
discharge. This discharge can cause server components to fail. When you unpack the
replacement part, open the package on a grounded antistatic mat. Always use an antistatic wrist
strap for hardware replacements.
Note - The CMIOU replacement kit includes a plastic cover to protect the CMIOU connectors.
When you unpack the new CMIOU, be sure to set the connector cover aside. You must install
this cover on the CMIOU that you return to Oracle.
1.
Determine which CMIOU requires service.
See “Identify Faulted Components” on page 36 and “CMIOU Indicators and
LEDs” on page 90.
2.
Determine whether the CMIOU is powered off.
-> show /System/DCUs/DCU_x/CMIOU_y power_state
3.
Determine your next step.
■
If the CMIOU is running (power_state=on), go to Step 4.
■
If the CMIOU is not running (power_state=off), go to Step 8.
4.
Determine to which PDomain the CMIOU is assigned.
-> show /System/DCUs/DCU_x host_assigned
/System/DCUs/DCU_x
Servicing CMIOUs 91
To Next Page
Need help?
General