Setup
Setting date and time
• The 12-hour system is used to
display the time.
3 Press the cursor button in the
center to enter the selection.
• The clock function starts at
[00] seconds when the cursor
button
in
the center
is
pressed.
• After pressing the MENU button to
finish the setting, check the date
and time display.
• Changing the date and time
display style
Press the MENU button, then select
[SETUP]
~
[DATEITIME]
~
desired
display style and then press the
cursor button in the center.
When the unit
is
turned on for the first
time, a message asking you to set the
date and time will appear.
• Select [YES] and press the cursor
button
in
the center. Perform steps 2
and 3 below to set the date and time.
If the screen shows the incorrect date
and time, then adjust it.
oRotate the mode dial to select
•
orO·
1 Press the MENU button, then
select [BASIC]
~
[CLOCK SET]
~
[YES] and
then press the cursor button
in the center.
MENU
2 Press the cursor button left or
right to select the item to be
set. Then, press the button up
or down to set the desired
value.
• The year will change as follows:
2000,2001,
",,2099,2000,
...
[DATE]
I
DEC.15.2007
[OFF]
I~-
[DIT]
DEC.15.2007
3:30
PM
40
VQT1D97
"")")"''(
·····
..
·v
w ..
>,
w.\.,,,.w,·yc
w
,····
··""
..
··l1lTT
YX'"
'.
•
.'
"
'1."->
(',
.•
,-
, w
_"jw,
ww
'.lW'
To Next Page
Loading...
Need help?
General