41
English
■ Menu screen of picture
You can adjust picture quality by either selecting [Picture] in the [Main Menu] and pressing the [OK] button of the
remote control, or by displaying the [Picture] menu with the [PICTURE] button of the remote control.
Picture
Picture Mode
Backlight
Color Temperature
Gamma
Noise Reduction
Adaptive Contrast
Over Scan
Aspect Ratio
Color Range
PC setting
Reset Picture Setting
Dynamic
100
11500
2.2
Middle
Off
Off
16:9
Automatic
Menu screen of picture
[Picture Mode] You can go to the [Picture Mode] menu by using the [OK] button of the remote control
and you can change to the following modes.
[Picture Style]: You can select the mode that is suitable to the image to be displayed.
[Dynamic]: Brightness will become maximum.
[Cinema]: It is suitable for playback of cinema contents.
[Custom]: It will use the custom image settings saved earlier ([Standard] settings are
used in the default mode). You can set a custom mode in [Picture Mode] -
[Custom] of the OSD menu screen.
[Standard]: It is the standard image quality.
•
[Cinema] will be available for selection according to the input signal.
You can make the following settings to determine the picture style.
[Contrast]: Adjusts the difference between light and dark of images.
[Brightness]: Adjusts light and dark of the entire screen.
[Sharpness]: Adjust the sharpness of image outlines.
[Tint]: Adjust the tint of entire images.
The hues of red, green, blue, yellow, cyan and magenta can be respectively set.
[Color]: Adjusts the colour of images.
The saturations of red, green, blue, yellow, cyan and magenta can be
respectively set.
Adjusting these will store the values as [Picture Style: Custom].
•
Depending on input images, changes occurring by adjusting these settings may be
small.
[Backlight] Adjusts the settings of back light.
[Color Temperature] Adjusts colour temperature and gain.
[Gamma] Selects the settings of gamma.
[Noise Reduction] It adjusts the extent of reducing noise.
[Adaptive Contrast] It turns on / off the function of automatically adjusting the contrast after determining how
to use the colours.
[Over Scan] Adjusts the settings of over scan. (It will not work in PC input.)
[Aspect Ratio] It adjusts the settings of aspect ratio.
•
When [Over Scan] is [Off], you can select only [4:3], [16:9], and [Dot By Dot].
To Next Page
Loading...
Need help?
General