31
30
USER MANUAL PANDORA ELITE V2
with coordinates and a web link to a map to your phone.
To end the session, hang up the phone.
Request GSM balance
1. Call the system number. Wait for the answer.
2. Dial 100*.
3. The system will confirm: ‘Balance information is sent via text message’ and will send text message with
account balance information to your phone.
To end the session, hang up the phone.
Tow truck mode
This mode is intended for car transportation with preservation of arming function. Tow truck mode
can be activated only when the system is armed, it will be deactivated automatically when disarming.
1. Call the system number. If the system is in PANIC mode, receive an emergency call. Wait for the answer.
2. Dial 15*, to enable the “Tow truck” mode, the system will disable motion, shock and tilt sensors. To
end the session, hung up the phone.
3. To disable this mode, disarm the system.
Activating/Deactivating engine blocking
You can block a car engine using any phone. The engine will remain blocked until phone command
‘Unlock engine’ will be sent and the “Secret PIN-code” will be entered. This blocking cannot be disabled
using a remote control or VALET button.
1. Call the system number and wait for the answer.
2. Dial 666* to block an engine or 999* to unlock it (after dialing 999* you should enter the “Secret PIN
code” that is located on the owner’s card).
!
All otheR commANds cAN be eNteRed IN the sAme mANNeR.
Changing settings via a phone
Disarm the system, call the system number, wait for the answer, switch on the ignition for 1-3 seconds
(but no more than 5 seconds), then switch it off. The system will enter the settings mode.
An example of changing the owner’s system number:
1. Enter the setting menu via a phone according to the instruction above;
2. Dial DTMF command 1*(phone number settings) and 1*(owner’s system number);
3. Enter new owner’s number in the format *XXXXXXXXXXX # (the system recognizes ‘*’ as ‘+’);
4. To confirm, dial 1*.
!
theRe ARe 3 WAys to chANGe mAIN oWNeR’s phoNe NumbeR:
1. vIA A phoNe, usING dtmf commANds settINGs mode.
2. usING RAdIo tAGs: tuRN oN the IGNItIoN WheN the system Is dIsARmed ANd cAll the system phoNe NumbeR. WAIt foR the
ANsWeR, dIAl the “Guest pIN-code” (defAult vAlue Is 1-2-3-4) If you ARe cAllING Not fRom the mAIN oWNeR’s NumbeR,
theN pRess ANd hold the buttoN oN the RAdIo tAG foR 2 secoNds (uNtIl the secoNd flAsh of the seNd INdIcAtoR).
ReleAse the buttoN, the system WIll RecoGNIze the INcomING phoNe NumbeR As the “mAIN oWNeR’s phoNe NumbeR.
3. usING the pANdoRA AlARm studIo oR pANdoRA bt ApplIcAtIoNs.
To Next Page
Loading...
Need help?
General
