EasyManuals Logo
Home>Pandora>Car Alarm>Elite v2

Pandora Elite v2 User Manual

Pandora Elite v2
27 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #9 background imageLoading...
Page #9 background image
17
16
USER MANUAL PANDORA ELITE V2
AN EXAMPLE OF USING THE FUNCTION
Turn on the ignition to disable engine blocking or enable service mode, turning on the ignition is not
required if you want to disarm the system or control time channels.
Enter the “Immobilizer PIN-code”. Press a programmed button/lever/pedal the number of times
equals to the first digit. Pauses between presses should not exceed 1 second. More than 1 second
pause will be interpreted as the start of the next digit input. The immobilizer code can consist max
of 4 digits from 1 to 9.
The system will confirm the correct input by a sound signal of the beeper and a programmed
function will be performed.
!
thIs mode Is dIsAbled by defAult. thIs mode cAN be set oNly by A pRofessIoNAl specIAlIst.
Checking the number of paired devices
The number of paired radio tags/mobile device can be checked by the number of flashes of the
LED indicator. The number of tags/mobile device can be checked when switching on the ignition (the
system must be disarmed). The number of green flashes will indicate the number of paired radio tags, a
following red flash will indicate a paired mobile device.
You can also check the number of paired radio tags/mobile device by taking off and putting back on
battery terminal. The system will emit short sound signals from a siren
:
First series of the siren signals
– indicates the number of paired radio tags;
The second long signal
after a pause of 2 seconds indicates a paired mobile devices.
REMOTE CONTROL D043
A two-way remote control is a mean of control over the system.
For easily distinguishable notifications the remote uses 16 ringtones. Each ringtone matches a
particular event. Remote has flashing LED indicators for additional information.
The remote is fully operational when shipped. To switch on the remote, press and hold the
button for 3 seconds. The “REMOTE ON” ringtone will play. Pressing and holding this button again for 3
seconds will cause the remote to switch off.
!
All coNtRol commANds ARe tRANsmItted vIA RAdIo chANNel, foR mAxImum effectIveNess ANd RANGe It Is RecommeNded
Not to shIeld AeRIAl AReA (see pIctuRe) WIth fINGeRs WheN usING A Remote coNtRol.
! A Remote coNtRol Is A uNIfIed coNtRol devIce. Its fuNctIoNs depeNd oN secuRIty system model.
868MHz
Antenna
SEND/ALARM
Indicator
OLED-
DISPLAY
micro-USB
ARM
DISARM
Unlock trunk
Beeper

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pandora Elite v2 and is the answer not in the manual?

Pandora Elite v2 Specifications

General IconGeneral
BrandPandora
ModelElite v2
CategoryCar Alarm
LanguageEnglish

Related product manuals