Pandora Elite v2 User Manual

41
40
USER MANUAL PANDORA ELITE V2
PANIC mode
If your car or you are in danger and you want to draw attention to your car, you can use PANIC mode. In
this mode the siren will sound
and turn signals will flash repeatedly for 30 seconds. To activate
this mode, use one of the methods described below.
Remote control
To activate the PANIC mode, press the
and buttons simultaneously. To switch it off, press
either
or
button.
Mobile applications Pandora Online and Pandora Pro
Open the mobile application. When the system is online (there is an Internet or Bluetooth connection),
press and hold the
button on the control panel until the scale is fully loaded. To switch this function
off press and hold the
button on the control panel until the scale is fully loaded.
Remote engine start
If the system is prepared for remote start, use one of the methods described below to start the
engine.
Remote Control
• To start the engine, press and hold the
button for 3 seconds (the remote control must be in
the radio coverage zone). Sound signal will confirm the command, LCD will show flashing the “engine is
arming
engine started
engine stopped
3 ashes
engine start
START
ENGINE
START
ENGINE
STOP
ENGINE
STOP
ENGINE
extension of launch
(10 min.)
321 *
321 *
123 *
3 sec.
3 sec.
2 sec.
running” icon signifying preparation to the engine start. In a few seconds the engine will be started,
the remote will play the “ENGINE START” ringtone and show spinning engine operation icon
.
The remote will give notification 1 minute before designated engine stop the
icon will flash
and the “ENGINE STOP IN 1 MINUTE” ringtone will play every 10 seconds. Sending the “REMOTE ENGINE
START” command (press and hold the
button for 3 seconds) while the “ENGINE STOP IN 1 MINUTE”
ringtone is playing will extend its operation period by 10 minutes. This procedure can be repeated
multiple times.
• To stop the engine, press and hold the button for 2 seconds or more (the remote control
must be in the radio coverage zone. The engine will be immediately stopped and it will be confirmed by
remote playing the “ENGINE STOP” ringtone and the “Engine is running” icon
.
Original key
The system reads digital information from a car, this allows you to start and stop the engine by an original key:
• To start the engine, press the “LOCK” button 3 times within 5 seconds (the key must be in the radio
coverage zone)
• To stop the engine, press the “LOCK” button 3 times within 5 seconds (the key must be in the radio
coverage zone).
! Remote eNGINe stARt by AN oRIGINAl key doesN’t RequIRed ANy AddItIoNAl settINGs. check If the fuNctIoN AvAIlAble foR
youR cAR IN loAdeR.pANdoRAINfo.com
! the fuNctIoN becomes AvAIlAble oNly 30 secoNds AfteR ARmING.
Phone
To start the engine, call the system number, wait for the answer. Dial the
command. If you
repeat the
command when the engine is running, it will prolong the operation period by 10
minutes (this procedure can be repeated multiple times).
•To stop the engine, call the system number, wait for the answer. Dial the
command.
Online service
• To start the engine, login to the PANDORA-ON.COM, when the system is online (there is an Internet
connection) press the START ENGINE button on the control panel. In a few seconds the engine will be
started, it will be confirmed with the spinning
icon.
• To stop the engine, press the STOP ENGINE button on the control panel. In a few seconds the
engine will be stopped and the spinning
icon will be faded.

Pandora Elite v2 Specifications

General

Brand	Pandora
Model	Elite v2
Category	Car Alarm
Language	English