10
Security-service system Pandora Light
Arming procedure
Arming the system allows monitoring of all security zones, locks the doors and blocks the engine.
To arm the system when the engine is stopped, shortly press
button on the remote control.
The siren will emit one sound signal and turn signals will flash once. The remote control will play
“ARMING” ringtone and security mode status icon (the lock) will change to
~~
short press doors locking
system arming
1 ash
press
and hold
for 1 sec.
For arming without sound confirmation press for more than 1 second.
If when arming doors, hood or trunk were open, the siren will sound 4 short signals instead of 1,
turn signals will flash 4 times, remote will play “WARNING!” ringtone (after “ARMING” ringtone) and will
show troubled zone. This zone sensor will be disabled at that moment. Sensor will be armed again in
15 seconds after the zone was set right.
For emergency arming when ignition is switched off, press and hold the VALET button for 3
seconds until the system confirms with red LED indicator flash. A car will be armed in 30 seconds.
Disarming procedure
To disarm the system, shortly press button on the remote control. You will hear 2 short siren
sounds and will see 2 flashes of turn signals. The remote will play “DISARMING” ringtone and security
mode status icon will change to:
~~
short
press
press
and hold
for 1 sec.
doors unlocking
system disarming
2 ashes
2 ashes
For disarming without sound confirmation press button for more than 1 second.
To Next Page
Loading...
Need help?
General
