14
Security-service system Pandora Light
responsiveness will be increased. If any security zone will be triggered, the engine will be immediately
stopped and alarm mode will be entered. Herewith all engine blocking functions will be activated.
Program neutral procedure (reservation mode)
(for cars with manual transmission)
If you are planning to use remote and automatic engine start on cars with manual transmission,
before arming you will need to perform following actions:
1. While ignition is on and engine is running, fixate the car with the handbrake and put the gear
lever to the neutral position. Program neutral procedure will be switched on automatically (it depends
on the system settings) or press and hold
button for 3 seconds to forced switch on this program.
2. Turn the key in the ignition lock to the OFF position (the engine should still be running) and
take it out of the lock.
3. Leave the car, close the doors.
4. Press
button to arm the car and lock the doors. The engine operation icon will be
spinning on LCD remote and security mode status icon
will be shown.
5. The engine will be stopped. Now the system is ready to perform remote and automatic engine
start.
xate the car using
a handbrake
leave the car, close the doors
OFF
ON
ACC
short
press
«engine stop»
ringtone
~~
in 3 sec.,
the engine will be stopped,
the system is ready
to perform remote start
To Next Page
Loading...
Need help?
General
