39
User manual
PROGRAMMING THE SYSTEM
Entering the programming mode
To change the system settings or program the system using a computer or VALET button, the system
must be in the programming mode. Enter the programming mode by entering the ‘Service PIN-code’
(factory preset is 1-1-1-1). The PIN-code should be entered using the external or located on the base
unit VALET button. The input is indicated by flashes of the external or located on the base unit LED
indicator. You can enter the code only if the base unit is powered from the USB socket or from an
external power supply, the ignition is off, the system is disarmed and service mode is switched off.
If there is no ‘Service PIN-code’, you can enter the programming mode using the ‘Secret PIN-code’
written on the owner’s card.
ATTENTION! You can nd the detailed instructions for entering the PIN code in the
‘Control over the system in case of emergency’ section.
Status indicators lights during PIN-code entering
LED state Description
Short orange ash Conrmation of pressing the VALET button
Short red ash Conrmation of entering a digit
Red and green ashes PIN-code is correct
Long red ash PIN-code is incorrect
Exiting the programming mode
To exit the programming mode, turn on the ignition or turn off power of the base unit. The system
will reboot programmatically (all changes will be saved) after exiting programming mode using the
ignition. All ways to exit the programming menu are accompanied by sound signals of the siren/beeper
and light signals of the LED indicator. Light signals indicate the number of recorded remote controls.
To Next Page
Loading...
Need help?
General
