37
User manual
CONTROL OVER THE SYSTEM IN CASE OF EMERGENCY
In case you cannot disarm the system using
a phone or immobilizer tag, the ‘Secret PIN-code’
can be used. The ‘Secret PIN-code’ is written on the
owner’s plastic card under protective layer. Erase the
protective layer and use the VALET button to input
the PIN-code.
The code must be entered only when the base
unit is powered and the ignition is switched off. The
PIN-code can be entered using the external or located
on the base unit VALET button. The digits input and
correct input is indicated by the external or located
on the base unit LED indicator.
ATTENTION! Make sure that the
protective layer on the owner’s plastic
card is intact after the installation of the
system. The plastic card hold the ‘Secret
PIN-code’.
ATTENTION! Remove the protective layer
carefully. Do not use any sharp objects to
avoid damaging of hidden information
under the protective layer.
ATTENTION! It is highly recommended to
change factory preset of the ‘Service PIN-
code’ for improving security of the system.
ENTERING THE PIN-CODE:
• Enter the first digit of the code using the VALET button. Press the button a number of times, equals
to the first digit. Pauses between presses should not exceed 1 second. Each pressing will be confirmed
with an orange LED indicator flash. Pause for more than 1 second and a red LED indicator flash confirm
the input of the first digit. Then you can enter the next digit
• Enter the second digit of the code using the VALET button. Press the button a number of times,
equals to the second digit. Pauses between presses should not exceed 1 second. Each pressing will be
Three-color status LED
indicator (green, red,
orange)
VALET button
VALET BUTTON
To Next Page
Loading...
Need help?
General
