29
User manual
Х7 Socket (Multifunctional channels)
Use this socket when implementing bypass of original immobilizer using IMMO-KEY1 and IMMO-KEY2
multifunctional channels. Deselect any logic of INP1 and INP7 inputs in settings. Make connections
in accordance with installation scheme. The settings of the socket are available in Alarm Studio.
Disconnect the system from power supply after changing the settings.
• Wire 1 (Green) (IMMO-KEY1 OUT/INP1) — Factory setting is ‘Trunk input’ This wire connects to an
appropriate wire that becomes grounded when the trunk opens. This input is multipurpose, it can
operate in accordance with selected logic.
• Wire 2 (White) — This channel is used to brake the circuit of original immobilizer (it connects in
accordance with an installation scheme).
• Wire 3 (Black) (IMMO-KEY2 OUT/INP7) — Factory setting is «Free input». This input is
multipurpose, it can operate in accordance with selected logic.
To Next Page
Loading...
Need help?
General
