26 GB/IE/NI
mode will be indicated on the LC dis-
play
2
by a flashing laser symbol
26
.
Note:
If not pressed any button for 30 sec-
onds, the laser beam will turn off
au-
tomatically. In this case, press the MEAS
button
6
to turn on the laser beam.
If not pressed any button for 60 sec-
onds, the display
2
will be turned
off automatically. In this case, press
the POWER button
12
to turn on the
display. Then, press the MEAS button
6
to turn on the laser beam.
3. Briefly press the MEAS button
6
again. The measured distance will be
appeared on the display
2
.
Note:
- New distance measurement can be
done by repeating step 2 to step 3.
- Measured values can be cleared by
pressing MODE button
10
.
Continuous distance
measurement mode
For continuous distance measurement,
f
ollow the step 1 & step 2 of single distance
To Next Page
Loading...
Need help?
General
