To Next Page

To Previous Page

INTELLIFLO

VS+SVRS and INTELLIPRO

VS+SVRS Variable Speed Pump Installation and User’s Guide

INTELLIFLO

VS+SVRS and INTELLIPRO

VS+SVRS Variable Speed Pump Installation and User’s Guide

Pump Operating Modes

The IntelliFlo

VS+SVRS Pump can be programmed three ways:

1. Manual Operation: Speed buttons 1-4 can be programmed for Manual operation. This

means the speed button is pressed and then the start button and the pump runs a programmed

speed. Speeds 5-8 can not be programmed for Manual operation because there are no buttons

associated with them.

To operate the pump in Manual Mode, press one of the four speed buttons, and press the

Start/Stop button to run the assigned speed for that button. When the pump is running a

Manual Speed Setting (speed 1, 2, 3 or 4 button pressed manually) and a scheduled speed is

set to run, the scheduled speed will take priority regardless of speed number of RPM. When

the Scheduled Speed’s time is over, it will not revert back to the manually pressed speed. If

the pump is running a schedule and a speed button is pressed manually, the pump will run the

manually selected speed until the next scheduled speed program.

2. Egg Timer (Duration): Speeds 1-4 can be programmed to run for a duration of time once

pressed. This means that the Speed button is pressed and then the start button and the pump

runs a programmed speed and the speed will turn off at the end of a preprogrammed amount

of time. Speeds 5-8 have no direct pump speed buttons and therefore cannot be programmed

with an Egg-Timer.

3. Schedule: The speed button can be programmed to turn on and off at a certain time. The

LED above the Start/Stop button must be lit for the pump to run schedules. When a speed is

set to run in Schedule mode it can still be operated manually. When a speed is programmed

to run 23 hours and 59 minutes per day it will not turn off. For example, for the pump to run

24 hours per day, program the pump to start at 8:00 AM and stop at 7:59 AM.

Programming the Pump

When the pump is running a manual speed and password time out is activated the pump can be turned

off but it cannot be turned back on. Pressing the Start/Stop button places it in the Running Schedule

mode. Therefore, it will only run Speeds that are Scheduled to come on at their scheduled Start Time.

Pentair INTELLIPRO VS+SVRS User Manual

Questions and Answers: