*Please note that the following settings will be available only when your access point is
operating in Router Mode.
Enter a number for your VLAN.
Check this box to enable routing between virtual LANs.
Check the Enable box to enable the DHCP Relay server.
Enter the IP addresses of one or two DHCP servers in the provided fields. The DHCP
servers entered here will receive relayed DHCP requests from the LAN. For
active-passive DHCP server configurations, enter active and passive DHCP server relay
IP addresses in DHCP Server 1 and DHCP Server 2.
This feature includes device information as a relay agent for the attached client when
forwarding DHCP requests from a DHCP client to a DHCP server. Device MAC address
and network name are embedded to circuit ID and Remote ID in option 82.
Enable logging of DHCP events in the eventlog by selecting the checkbox.
When this setting is enabled, the DHCP server automatically assigns an IP address to
each computer that is connected via LAN and configured to obtain an IP address via
DHCP. The Pepwave router’s DHCP server can prevent IP address collision on the
LAN.
To Next Page
Loading...
Need help?
General