24
Allocating a decoder
Some TV channels send coded TV signals that can only be viewed properly with a purchased or
rented decoder. You can connect such a decoder (descrambler) to your DVD recorder. The
following function automatically activates the connected decoder for the TV channel you want to
watch.
How do I allocate the decoder for Easy Link?
If your TC=V set supports 'Easy Link' the decoder must be assigned to the
relevant TV channel on the TV set (see the operating instructions for your TV
set). Settings cannot then be made in this menu.
?
1 Switch on the TV set. If required, select the programme number for
the DVD recorder.
2 Switch on the DVD recorder using STANDBY/ON m .
3 Use the CH+ A and CH- B buttons or the number buttons
0..9 on the remote control to select the TV channel for which you
want to use the decoder. If necessary, use the MONITOR button to
switch to the internal tuner.
4 Press the SYSTEM-MENU button on the remote control. The menu
bar appears.
5 Select '
A
' symbol with D or C .
6 Select 'Installation' using CH- B or CH+ A and confirm with C .
7 Select 'Manual search' using CH- B or CH+ A and confirm with
C .
Installation
Manual search
Channel/freq. CH
Entry/search 01
Programme number 01
TV channel name BBC1
Decoder Off
TV system PAL-BG
NICAM On
Fine tuning 0
To store
Press OK
8 Select 'Decoder' using CH- B or CH+ A .
9 Select 'On' with D or C .
How do I switch the decoder off again?
Use C to select 'Off' in the 'Decoder' line on the screen (Decoder off).
?
0 Confirm with OK .
A To end, press SYSTEM-MENU .
Your decoder has now been allocated to this TV channel.
Installing your DVD recorder
To Next Page
Loading...
Need help?
General
