IIIIIIIIIIIIIII Disc bar: Displays the current position on the disc (disc pointer).
Play/Record: Single flashing segment at the current position.
Pause: Flashing segment on both sides of the current position.
Stop: Illuminated segment at the current position.
SAT A satellite recording has been programmed.
TIMER A recording (timer) has been programmed
o((( A remote control signal has been received
VPS/PDC Video programming system / programme delivery control: A VPS or
PDC code will be transmitted for the selected TV program
LANG II During playback a HiFi/2 channel tone was detected or a HiFi/2 channel
tone was received. 'I' or 'II' lights up depending on which sound channel
has been selected
Messages in the DVD recorder display
READING
The following messages may appear in your DVD recorder display
IS TV ON? The DVD recorder is in initial installation mode. Switch the TV on, then
read the paragraph on 'Initial installation' in 'Installing your DVD
recorder'.
NO SIGNAL No input signal available (signal inadequate or unstable)
MENU The menu on the screen is active
OPENING Disc tray opening
TRAY OPEN Disc tray open
CLOSING Disc tray closing
READING Disc being read
MENU UPDT Once recording has been successfully completed the table of contents is
created.
INIT MENU The menu structure is created after the first recording has been made
on a new disc
COPY PROT You have tried to copy a copy-protected DVD/video cassette.
WAIT Please wait until this message disappears. The DVD recorder is busy
performing a task.
NO DISC A disc has not been inserted for recording. If a disc has been inserted, it
cannot be read.
INFO Information about the inserted DVD is displayed on the screen
BUSY The DVD recorder is processing the changes to make them DVD
compatible
ERASING The entire disc is erased
ENGLISH
To Next Page
Loading...
Need help?
General
