Pioneer A-40AE User Manual

15
Preparations
En
Depending on the speakers you connect and how you
connect them, you may need to change the speaker
impedance setting on this unit. Refer to the page describing
speaker connection (p8, 9, 10) and do the following
procedures if the change is required.
1. Press and hold DIRECT until some indicators, such as
the input source indicators "CD/SACD" and "LINE 1", start
blinking on the unit.
0 The unit has switched to the setting mode when the
indicators blink and the current setting is displayed.
2. Take your finger off DIRECT for a moment.
3. Press and hold DIRECT again to change the setting. The
following content switches alternately by pressing and
holding the button.
-4 ≠: "CD/SACD" and "LINE 1" indicators are blinking
-8 ≠ (default value): "CD/SACD", "LINE 1", "LINE 2",
and "LINE 3" indicators are blinking
0 The setting mode ends after 5 seconds elapse with no
operations performed.
Speaker impedance settings
4Ω8Ω
3"
3"
3
1
2
SN29403415_A-40AE_En_1804XX.book 15 ページ ２０１８年５月２３日 水曜日 午後３時１９分

Pioneer A-40AE Specifications

General

Purpose	-
Material	Aluminium, Steel
Product color	Black
Volume control	Rotary
Bass adjustment	Yes
Connectivity technology	Wired
Frequency range	10 - 100000 Hz
Audio output channels	- channels
Peak power per channel	- W
Signal-to-Noise Ratio (SNR)	106 dB
Total Harmonic Distortion (THD)	- %
Built-in display	No
Digital audio optical in	1
AC input voltage	220 - 230 V
AC input frequency	50 - 60 Hz
Power consumption (standby)	0.2 W
Power consumption (typical)	150 W

Weight and Dimensions

Depth	323 mm
Width	435 mm
Height	129 mm
Weight	8200 g