1 Use MULTI-CONTROL to select
Door mute 2 in the initial setting menu.
Refer to Adjusting initial settings on page 35.
2 Press MULTI-CONTROL to switch the
door muting/attenuation.
Each press of MULTI-CONTROL selects set-
tings in the following order:
OFF (off)—20dB ATT (20 dB attenuation)—
MUTE (mute)
Switching the reverse mode
If you do not perform an operation for about
30 seconds, screen indications start to reverse,
and continue reversing every 10 seconds.
1 Use MULTI-CONTROL to select
Reverse mode in the initial setting menu.
Refer to Adjusting initial settings on page 35.
2 Press MULTI-CONTROL to turn the re-
verse mode on.
# To turn the reverse mode off, press
MULTI-CONTROL again.
# You can also turn on or off reverse mode by
pressing B while this unit is turned off. For more
details, refer to Reverse mode on page 8.
Switching the ever scroll
When ever scroll is set to on, literal informa-
tion such as CD title scrolls continuously in
the display. Set to off if you prefer the informa-
tion to scroll just once.
1 Use MULTI-CONTROL to select
Ever-scroll in the initial setting menu.
Refer to Adjusting initial settings on page 35.
2 Press MULTI-CONTROL to turn the ever
scroll on.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Activating the BT Audio source
You need to activate the BT Audio source in
order to use a Bluetooth audio player.
! You can only operate this function when
Bluetooth adapter (e.g. CD-BTB200) is con-
nected to this unit.
1 Use MULTI-CONTROL to select
BT AUDIO in the initial setting menu.
Refer to Adjusting initial settings on page 35.
2 Press MULTI-CONTROL to turn the
BT Audio source on.
# To turn the BT Audio source off, press
MULTI-CONTROL again.
Entering PIN code for
Bluetooth wireless connection
To connect your cellular phone to this unit via
Bluetooth wireless technology, you need to
enter PIN code on your phone to verify the
connection. The default code is 0000, but you
can change this in this function.
! With some Bluetooth audio players, you
may be required to enter the Bluetooth
audio player PIN code in advance to set
this unit for a connection.
! You can only operate this function when
Bluetooth adapter (e.g. CD-BTB200) is con-
nected to this unit.
1 Use MULTI-CONTROL to select
Pin code input in the initial setting menu.
Refer to Adjusting initial settings on page 35.
2 Push MULTI-CONTROL up or down to
select a number.
3 Push MULTI-CONTROL left or right to
move the cursor to the previous or next po-
sition.
4 After inputting PIN code (up to 16 di-
gits), press MULTI-CONTROL.
PIN code can be stored in memory.
Initial Settings
En
39
Section
04
Initial Settings
To Next Page
Loading...
Need help?
General
