102
MAINTENANCE AND LUBRICATION
Engine Cooling System
Radiator Coolant Level Insp ectio n
NOTE: This procedure is
only required if the cooling
system has been drained for
maintenance and/or repair.
However, if the recovery bottle
has run dry, the level in the
radiator should be inspected
and coolant added if necessary.
To access the radiator pressure
cap:
Gen III (A) - To access the
pressure cap, clean the area
around the oil cap and remove
the oil cap (2-cycle models).
Remove front cover by placing
your fingers under the front of
the cover and pulling upward.
Reinstall oil cap.
Gen IV (B) - Using the tool
provided, remove the four
screws securing front rack (2).
Remove front cover (3) by
placing your fingers under the
front of the cover and pulling
upward.
Never remove the pressure cap when the engine is warm or hot.
Escaping steam can cause severe burns. The engine must be
cool before removing the pressure cap.
WARNING
1
3
2
A
B
To Next Page
Loading...
Need help?
General
