166
MAINTENANCE AND LUBRICATION
Cleaning and Storage
Storage Tips
Cleaning - Outside...Make necessary repairs and then clean the ATV
thoroughly with a mild soap and warm water solution to remove all dirt
and grime. Don’t use harsh detergents or high pressure washers. Some
detergents deteriorate rubber parts - use dish soap type cleaners only.
High pressure washers may force water past seals. Drain the recoil
housing.
Stabilize Fuel - F ill the fuel tank. Add Polaris Carbon Clean Fuel
Treatment or Polaris Fuel Stabilizer. Follow instructions on the
container for recomme nded amount. Carbon clean will also reduc e the
possibility of bac te rial growth in the fuel system. It’s best to allow 15-20
minutes of operation for the stabilizer to disperse through the fuel in the
tank and carburetor. T urn the fue l valve to “OFF” and drain the
carburetor bowl completely.
Oil And Filter Change - (4-Strokes) Warm the engine and change oil
and filter.
Air Filt er / Air Box - Inspect and clean or replace the pre-cleaner and air
filter. Cle an the air box and drain the sedime nt tube.
Breather Filter(s) - On 4-Strokes, inspect and clean or replace the
breather filter(s).
Inspect All Fluid Levels - Inspect the following fluid levels and
change if necessary: engine counter balance (2-strokes); front gear case
(shaft drive models); transmission; front hubs (AWD models); brake
fluid (change every two years or as required i f fluid looks dark or
contaminated).
Drain Recoil Housing - Remove drain plug from recoil housing and
drain any moisture present.
Do not start the engine during the storage period. This will disturb
the protective film created by fogging.
CAUTION
To Next Page
Loading...
Need help?
General
