Polaris ATV 2002 User Manual

127
MAINTENANCE AND LUBRICATION
Filter Systems
Air Cleaner - 2 Cycle Engin es
Filter Removal and Service Procedure
1. Remove the ATV seat.
2. Unsnap the clips holding the cover assembly to the air box.
3. Loosen clamp securing the filter and remove the filter.
4. Remove the foam pre-filter from the main filter.
5. Wash pre-filter in soapy water, rinse and let dry.
6. Re-install pre-filter over main filter. Replace main filter if
required.
Filter Installatio n Procedure
1. Check condition of airbox and replace if necessary.
2. Replace filter over carburetor boot. Make certain filter is fully
seated in the air box.
3. Tighten clamp. Do not overtighten or filter damage may occur.
4. Check cover gasket and replace if required. B e certain the cover is
seated properly and snap the clips on to the cover.
5. Reinstall ATV seat.

Polaris ATV 2002 Specifications

General

Brand	Polaris
Model	ATV 2002
Category	Offroad Vehicle
Language	English