67
OPERATION
Break-In Period
2-Cycle Engines
The break in period for your new Polaris ATV is defined as the time it
takes to use the first tank of gasoline. No single action on your part is
as important as a proper break in period. Careful treatment of a new
engine will result in more efficient performance and longer life for the
engine. P erform the following procedures carefully.
1. Mix 12.8 ounces of injection oil to four gallons (or 16 ounces to 5
gallons) of gasoline in a suitable gas can. Fill the fuel tank as
outlined on page 49.
2. Fill the oil tank with Polaris injection oil.
3. Drive slowly at first. Select an area which is open and will give
you room to familiarize yourself with vehicle operation and
handling.
4. Vary the throttle positions.
5. Perform regular checks on fluid levels, controls and all important
areas on the vehicle as outlined earlier on the daily pre-ride
inspection checklist found on page 66.
Use only Polaris injection oil. Never substitute or mix oil brands.
Serious engine damage and voiding of warranty can result.
CAUTION
Do not operate at full throttle or high speeds for extended
periods during the first three hours of use. Excessive heat can
build up and cause damage to close fitted engine parts.
CAUTION
To Next Page
Loading...
Need help?
General
