Polaris GEM e6 User Manual

7 - 5 BODY
BODY SIDE PANEL
(6 PASSENGER ONLY)
Fig. 3 Side panels
1 - Front panel
2 - Middle panel
3 - Rear panel
FRONT
1. Remove the upper and lower dash. See Dash
in this section.
2. Remove the mudguards. See Mudguards in this
section.
3. Remove the scuff guard (sill plate),
(if equipped). See Scuff Guards in this section.
4. Remove the (7) body side rivets.
5. Remove the side panel.
6. To install reverse this procedure.
MIDDLE
1. Remove the scuff guard (sill plate), (if
equipped).
2. Remove the (10) body side rivets.
3. Remove the center side panels.
4. To install reverse this procedure.
REAR
1. Remove the swivel pack or utility box. See
Swivel Pak or Utility Box.
2. Remove the rear bench seat cushion. See
Bench Seat in this section.
3. Remove the scuff guard (sill plate), (if
equipped). See Scuff Guards in this section.
4. Drill out (5) rivets from the back body panel.
5. Remove the (7) body side rivets.
6. Remove the side panel.
7. To install reverse this procedure. Install new
rivets and set in place with a proper rivet tool.
GEM Service Manual November 2007

Polaris GEM e6 Specifications

General

Brand	Polaris
Model	GEM e6
Category	Utility Vehicle
Language	English