Polaris GEM e6 User Manual

4 - 14 BRAKES
GEM Service Manual November 2007
INSTALLATION
TWO PASSENGER, SHORT BED UTILITY, LONG
BED UTILITY COUPE MODELS
1. Position the park brake lever assembly.
2. Replace the mounting bolts through park brake
lever brackets.
3. Connect the park brake switch wires to proper
terminals on switch: Red/White on center
terminal, and Tan on upper (most forward)
terminal.
4. Insert adjusting rod into park brake cable
equalizer, replace adjusting and jam nuts.
5. Adjust tension on park brake cables. See Park
Brake Cable Tension Adjustment in this section.
6. Install the lower seat. See Bench Seat in Body
section.
7. Switch master disconnect switch ON.
FOUR PASSENGER & SIX PASSENGER SEDAN
MODELS
1. Position the park brake lever assembly.
2. Install the mounting bolts through park brake
lever brackets.
3. Connect the park brake switch wires to proper
terminals on switch: Red/White on center
terminal, and Tan on upper (most forward)
terminal.
4. Insert adjusting rod into park brake cable
equalizer, replace adjusting and jam nuts.
5. Adjust tension on park brake cables. See Park
Brake Cable Tension Adjustment in this section.
6. Switch master disconnect switch ON and install
parking brake lever boot.
PARKING BRAKE CABLE
ASSEMBLY
DESCRIPTION
Two cables are attached to the park brake lever by
a tension equalizer and to the park brake actuator
levers on the rear brake assemblies.
Fig. 11 Park Brake Cables
1 - Park brake cables
2 - Cable mounting bracket
3 - Actuator lever

Polaris GEM e6 Specifications

General

Brand	Polaris
Model	GEM e6
Category	Utility Vehicle
Language	English