Polycom G7500 Reference Guide

Quality of Service Parameters
Topics:
▪ Quality of Service Parameters
This section describes available quality of service (QoS) configuration parameters. Included are permitted
values and, if applicable, guidance for configuring related parameters.
Quality of Service Parameters
Use the following parameters to configure QoS settings on your G7500 system.
qos.tosType
Specifies the type of service (ToS), which lets you prioritize packets sent to your system for
video, audio, Far End Camera Control (FECC), and OA&M
IP_Precedence (default) - Uses a priority level between 0 and 7.
DiffServ - Uses a priority level between 0 and 63.
qos.diffServ.audio
Specifies the DiffServ priority level for audio RTP and associated RTCP traffic.
Integer (0-63)
0 (default)
qos.diffServ.video
Specifies the DiffServ priority level for video RTP and associated RTCP traffic.
Integer (0-63)
0 (default)
qos.diffServ.fecc
Specifies the DiffServ priority level for control traffic on the following channels:
H.323: H.225.0 Call Signaling, H.225.0 RAS, H.245, and FECC.
SIP: SIP Signaling, FECC, and Binary Floor Control Protocol (BFCP).
Integer (0-63)
40 (default)
Note: FECC is enabled by video.camera.farControlNearCamera.
qos.diffServ.oam
Specifies the DiffServ value for traffic unrelated to video, audio, or FECC.
Integer (0-63)
16 (default)
qos.dynamicBandwidth.enable
Polycom, Inc. 56

Polycom G7500 Specifications

General

Brand	Polycom
Model	G7500
Category	Conference System
Language	English