Software Update Parameters
Topics:
▪ Software Update Parameters
This section describes available software update configuration parameters for your system. Included are
permitted values and, if applicable, guidance for configuring related parameters.
When you update your system, you also update some of its connected peripheral devices (if those
devices have a new version available). Depending on your setup, these devices might include:
▪ Polycom IP Table Microphone
▪ Polycom IP Ceiling Microphone
▪ Polycom Microphone IP Adapter
Software Update Parameters
Use the following parameters to configure software update settings on your G7500 system.
upgrade.auto.enable
Controls whether the software of your system and its connected peripheral devices
automatically updates.
0 (default)
1
upgrade.auto.timeFrame.enable
If you've configured automatic software updates (upgrade.auto.enable="1"), you can restrict
those updates to occur only during a maintenance window.
If set to "1", make sure you also configure upgrade.auto.timeFrame.startTime and
upgrade.auto.timeFrame.stopTime.
0 (default)
1
upgrade.auto.timeFrame.startTime
Specifies when the maintenance window starts. Set a value using 24-hour clock format
(HH:MM). For example, "23:30" is an acceptable value.
String
18:00 (default)
upgrade.auto.timeFrame.stopTime
Specifies when the maintenance window ends. Set a value using 24-hour clock format
(HH:MM). For example, "05:30" is an acceptable value.
String
07:00 (default)
upgrade.auto.polling.interval
Polycom, Inc. 87
To Next Page
Loading...
Need help?
General
