The housing must be properly closed, otherwise it may not adequately protect people or
property from any abnormal situation inside the equipment.
Always follow the instructions in the manual to move and position the equipment. The weight of
this equipment can cause injuries, serious injuries and even death if not handled correctly.
The output airflow can reach high temperatures that could harm people exposed to it.
Electric shock danger. The steps to isolate the equipment must be carefully followed before performing
any task or opening any cover of the equipment. Avoid inappropriate actions that may cause electric
shock.
Always wear the appropriate personal protective equipment (PPE) for each task and work in
electrical areas with dry hands. Otherwise, you may get an electric shock.
Do not use cables with damaged insulation. Do not subject cables to abrasion, excessive stress,
heavy loads or pinching. Otherwise, you may get an electric shock.
Do not supply power to a damaged equipment or with missing parts, even if the installation is
complete. Otherwise, you may get an electric shock.
In the event that the equipment stops due to a loss of power, do not do any work on it. The auto-
restart function may be enabled, and you may receive an electric shock.
The equipment has capacitors. Wait until the capacitors have discharged before performing any
maintenance task.
USE
Do not use this equipment for purposes other than the electric vehicle charging with the modes
provided for this product and defined in this manual.
Do not disconnect or connect any terminals while the equipment is running. Otherwise, you may
get an electric shock and the equipment may be damaged.
Do not use this product if its enclosure or electric vehicle connector(s) (on both the equipment and
vehicle sides) are broken, cracked or otherwise damaged. Otherwise, you may get an electric shock.
CONNECTION TO EARTH
Prevention of electric shock:
• The equipment chassis must be properly grounded to prevent a possible electrical shock if a
leakage current flows through the enclosure. Disconnect all power supplies before proceeding
with maintenance operations inside the equipment.
• Only connect the grounding device to the equipment's grounding plate. Do not use the enclosure
or chassis screws for grounding.
• The protective earth wire must be connected first and last disconnected.
To Next Page
Loading...
Need help?
General
