The shutdown of the equipment must only be carried out by personnel qualified. Read these
instructions and all safety recommendations carefully. Otherwise, the equipment could be damaged and
seriously injured personnel.
The instructions in this manual do not replace or replace local or national regulations. It is the
user's responsibility to comply with all safety standards that apply at the installation site.
The following steps describe the process to follow for disconnecting the charging station NB 50 / NB 60.
End the charging process if it were active.
Disconnect the external AC voltage input and block.
Wait the time indicated on the protection label to avoid electrical hazards. Time for
discharge of stored energy and cooling of components. After this time and when the light
signal indicates that the voltage is no longer present, with the appropriate PPE, check that
the DC capacitors are discharged by measuring the bus on the connection card.
With the appropriate PPE, check the absence of voltage at the AC input.
Delimit and signal the work area.
To Next Page
Loading...
Need help?
General
