2Operation Verification
Use the Operation Verification Checklist to verify the bike operation. Verify the bike operation
at the completion of any maintenance procedure and when it is necessary to ensure that the
bike is operating properly.
Operation Verification Checklist
Do an overall visual inspection of the bike looking for any loose hardware and/or
missing parts Repair and replace as needed.
Verify that the bike sets level and is stable on the floor, see "Leveling Adjustment
Procedure" on page15.
Verify that the seat height and forward/back adjustment operate correctly.
l Make sure that the seat post up/down movement is smooth and that the
pop-pins lock at different positions. .
l Make sure the forward/back slider movement is smooth and the adjust-
ment knob locks the seat in position.
Verify that the handlebar height and forward/back adjustment work correctly.
l Make sure the handlebar post up/down movement is smooth and that the
pop-pins lock at different positions.
l Make sure the forward/back slider movement is smooth and the adjust-
ment knob locks the handlebar in position.
Set the resistance to minimum and pedal the bike at a moderate pace (55 rpm or
greater), increase the resistance to maximum and return to zero resistance.
l Verify that the resistance knob functions normally from min to max res-
istance.
l Verify that there were no unusual noises from the brake pads or flywheel
during operation.
l Verify that at maximum resistance, the bike was very hard to pedal.
Commercial use: Release all tension from the resistance knob when the oper-
ational check is completed.
Residential use: Use resistance knob to apply a small amount of resistance when
the operational check is completed.
.
Page 7
2 Operation Verification
To Next Page
Loading...
Need help?
General
