Belt/Chain Guard Cover Replacement
About
This procedure provides instruction to remove and install the front and rear Belt/Chain Guard
Covers.
The front belt/chain guard includes an access panel used to access the tensioner nuts and
right axle nut. The rear cover includes a chain tension window that allows you to verify the
chain tension. It is easiest to remove the rear guard cover first and then the front guard cover,
install in reverse order. All rear guard fasteners must be removed before the front guard can
be removed.
Available Movies
(Internet Only)
Belt/Chain Guard Cover Replacement
Procedure
Review entire procedure before starting.
Removal instructions
1.
Remove the rear belt guard cover by removing the fasteners (4x) using a 5 mm hex
key. Remove stared fastener last. Retain fastener hardware for installation.
Front Access Panel guard cover removal instructions
18
4 Replacement Procedures
Belt/Chain Guard Cover Replacement
To Next Page
Loading...
Need help?
General
