Precor SPINNER SHIFT User Manual

Belt Drive Issues
Applies To
All belt drive spinner series bikes.
Issues
Issues related to the belt drive bikes:
ISSUE CAUSE SOLUTION
Excessive belt
noise.
l Belt tension out-
of-spec.
l Worn belt.
Verify and adjust belt tension, see "Belt Drive
Tension Adjustment" on page9.
If tension is within spec, inspect belt condition
and replace if worn, see "Belt and Flywheel
Replacement" on page21.
Pedal slips
when pedaling
with power.
l Loose belt, ten-
sion out-of-spec.
l Worn belt.
Verify and adjust belt tension, see "Belt Drive
Tension Adjustment" on page9.
If tension is within spec, inspect belt condition
and replace if worn, see "Belt and Flywheel
Replacement" on page21.
Belt comes off
pulley
l Loose belt.
l Misaligned belt
pulley alignment.
Verify and adjust belt tension, see "Belt Drive
Tension Adjustment" on page9.
Check the front to rear belt pulley alignment. Can-
not be adjusted, check the left/right flywheel axle
bracket condition or possible a bent frame.
See Also
"Troubleshooting" on page57
59

Precor SPINNER SHIFT Specifications

General

Brand	Precor
Model	SPINNER SHIFT
Category	Exercise Bike
Language	English