Page 5 of 68
Proton Products InteliSENS PD30 Instruction Manual (Issue 1a)
DECLARATION OF CONFORMITY (CE)
Proton Products International Limited declares that the equipment listed below fulfils the requirements
of directive EMC: 2014/30/EU and Low Voltage: 2014/35/EU.
The following standards were applied:
Radio - ETSI EN 300 328 V2.1.1 (2016-11)
EMC - EN 61326-1:2013
Low Voltage - EN 61010-1:2010 (Scientific and measuring instruments)
Health and Safety - EN 60950-1:2006+A11:2009+A1:2010+A12:2011+A2:2013, EN 62311:2008
Equipment Covered
Single Axis diameter gauge
Colour touch screen display interface
These products carry the CE Mark:
Warning – laser equipment
The diameter gauge contains a laser source that complies with EN60825 Class 2 under normal use. If
the gauge is opened, the laser source removed and tampered with then the source can become Class
3.
The manufacturer of the above named equipment is:
Proton Products International Limited
10 Aylesbury End
Beaconsfield
Bucks
HP9 1LW
ENGLAND
Proton Products is an ISO9001:2015 registered company.
The declaration is signed by:
Paul Sives ………………………
To Next Page
Loading...
Need help?
General
