Page 6 of 68
Proton Products InteliSENS PD30 Instruction Manual (Issue 1a)
INTRODUCTION
GAUGE PD30 WITH CDI4 DISPLAY
The InteliSENS PD30 Single Axis Laser Scanning Diameter Gauge provides fast, accurate and
repeatable diameter measurements of cables or other objects manufactured in a continuous process.
The PD30 measures objects or cables up to 30 mm in diameter, by a non-contact method. The
gauge contains a single-axis optical scanning system and a processing circuit to produce diameter
and statistical data.
When fitted with the optional CDI4 interface display unit, the InteliSENS PD30 diameter gauge can
operate as a standalone unit.
RS-232, RS-422, RS-485 and Ethernet communication interfaces are installed as standard for
straightforward connection to computers or PLCs. Optional industrial standard communication
interfaces (PROFIBUS, PROFIBNET, EtherNet/IP or WiFi) can be specified for installation at time of
manufacture.
Analogue and pulsed line speed inputs are fitted as standard to provide line speed data to the gauge
for optional PI feedback control and SMFD (Single Measurement Flaw Detection).
User configurable logic inputs are provided as standard to reset gauge measurements and trigger
printing. User configurable relay outputs are provided as standard to signal gauge status, lump and
neck detection and measurements exceeding preset error limits.
To Next Page
Loading...
Need help?
General
