28
- Use only those accessories or special
equipment that are offered for the ma-
chine by the manufacturer.
- All repairs must be performed only by
an authorised service centre by prop-
erly qualifi ed personnel, using original
replacement parts. The warranty does
not cover any damages caused by the
use of any inappropriate parts.
5.3 Residual safety risks
Even if the machine is used to specifi cation
and all relevant safety regulations are fol-
lowed, the following residual safety risks
may nonetheless occur due to the design
of the machine and its usage:
- Injury from the cutting teeth when re-
placing the chain.
- Injury from touching the chain on its cut-
ting area.
- Catching clothes in the moving chain.
- Injury from fl ying scraps or parts of the
machine.
- Danger that may be caused by the port-
able cord.
- Kickback caused by the chain or the op-
erating the tip of the plate jamming.
- Concentration of sawdust jeopardising
health in poorly ventilated areas.
- Injury from touching electrically charged
parts when dismantling the machine or
any part of it while the machine is still
plugged in.
- Hearing damage from prolonged work
without ear protectors.
5.4 Noise / Vibration Information
Measured values determined according to
EN 60 745.
Typically the A-weighted noise levels of the
tool are:
Sound pressure level: 92 dB (A).
Sound power level: 103 dB (A).
Acoustic output value measured according
to established guideline 2000/14/EC, ap-
pendix VI.
L
WA
= 103 dB (A)
L
WAd
= 105 dB (A)
Measurement was performed by notifi ed indi-
vidual No. ES-1014 EZU s. p. Pod Lisem 129,
171 02 Prague 71.
Inaccuracy of measurement K = 3 dB (A).
CAUTION
The noise created during work may dam-
age hearing.
► Use hearing-protective aids!
The typical hand-arm vibration is 3.4 m/s
2
.
Inaccuracy of measurement K = 1.5 m/s
2
.
6 Transport and delivery
The SSP 200 EB sword saw is delivered in
perfect, tested condition, packed in a plastic
systainer. The oil reservoir of the machine
SSP 200 EB is not fi lled. When the machine is
delivered, take it directly out of the packaging
and check for potential damage during trans-
port. Any damage caused during transport
must be reported to the carrier immediately.
6.1 Storage
The packed sword saw can be stored in a dry
storage area without a heating, where the
temperature does not drop bellow –5 °C.
Store the unpacked saw only in a dry closed
storage where the temperature does not
drop below +5 °C, and where sudden tem-
perature changes are prevented.
7 Adjustment
CAUTION!
All adjustments and settings must be carried
out before the machine is switched on.
WARNING
Danger of electrical injury.
Unplug any tool before handling.
Wear protective gloves!
7.1 Tilting the guide bar length-
wise
The guide bar, including the guard plate,
can be tilted 10° backward. This adjust-
ment is mainly used when multiple layers
are cut at the same time. It prevents resist-
ance to the tool and an uneven cut.
- Release lever [3-1] upward (Fig. [3a]).
- By pulling the handle, tilt the guide bar
backwards and secure it again with the
lever [3-1] downward (Fig. [3b]).
To Next Page
Loading...
Need help?
General
