Rins136 Issue 9 Page 3
Contents
1 INTRODUCTION 5
2 SAFETY
6
3 ACCESS LEVELS
8
4 OPERATING MODES
9
5 ZONES
9
5.1 Programmable Zones
9
5.2 Dedicated Zones
9
6 CONTROLS AND FUNCTIONS
10
7 INSTALLATION
13
7.1 Panel Assembly (Steel Version)
14
7.2 Panel Assembly (Plastic Version)
15
8 POWER CONNECTIONS
17
8.1 Mains Connections
17
8.2 Battery Connection
17
8.3 Bell and Strobe (Transistor Version)
17
8.3.1 Bell and Strobe (Relay Version)
17
8.4 Remote Keypad ‘RKP’ Connections
18
8.4.1 Wiring to Single Remote Keypad
18
8.4.2 Wiring to Multiple Remote Keypads (Daisy Chain)
18
8.4.3 Wiring to Multiple Remote Keypads Star Configuration)
18
8.5 Detection Zones
19
8.6 Tamper and Auxiliary
19
8.7 Personal Attack PA
19
8.8 Push To Set
19
8.9 Speaker
19
8.10 Digital Communicators
20
8.11 Programmable Outputs
20
8.12 Shock Sensors
20
8.13 Battery Capacity
21
8.14 Powering Up Your Panel / RKP
21
9 PROGRAMMING
22
9.1 Factory Defaults
22
9.2 Entering Engineer Mode
22
9.3 Setting Volume Control
22
9.4 Setting the Panel when Mains Fails
23
9.5 Programming Set Modes 23
9.6 Setting the Alarm Bell Time 23
9.7 Setting Entry Time
23
9.8 Setting Exit Time
23
9.9 Setting Bell Delay
23
9.10 Setting Communication Delay
23
9.11 Changing the Engineer Code
24
9.12 Programmable Outputs
24
9.12.1 Programmable Output 1
24
9.12.2 Programmable Output 2
24
9.12.3 System Option 1
24
9.12.4 System Option 2
24
9.12.5 System Option 3
24
9.12.6 System Option 4
25
9.12.7 Programmable Re-sets
25
9.12.8 Service Timer
25
9.13 Keyswitch Set Configuration
25
9.14 Reseting The Non Volatile Memory (NVM) To Factory Settings
25
9.15 Communicator Test
26
9.16 Anti Code Algorithm
26
9.17 Set A Set Option
26
9.18 Set B Set Option
26
9.19 Set C Set Option
26
To Next Page
Loading...
Need help?
General
