Rins136 Issue 9 Page 5
1 INTRODUCTION
The Sterling 10 intruder alarm control panel is based around a micro-controller with 8 fully programmable zones.
Operated via a single Remote keypad situated at a convenient point around the premises. Up to four additional keypads
may be installed. Each keypad has an arrangement of 8 LEDs to show the status of the system, and a 7 segment display
to show programming data and events held in the event-log memory.
All features are fully programmable and there are three levels of access to the system.
The Limited User codes allow access to the basic functions needed for everyday setting and unsetting of the system.
The Master User level gives access to all setting and unsetting facilities, but also allows the changing of code numbers
and testing of the system.
The Engineer level gives total access to the system including the ability to re-configure the system and reset the system
event-log memory. The Engineer cannot, however, unset the system.
To Next Page
Loading...
Need help?
General
