LPWA Module Series
BG96 Hardware Design
BG96_Hardware_Design 54 / 79
Table 30: Antenna Requirements
1)
It is recommended to use a passive GNSS antenna when LTE B13 or B14 is supported, as the use of
active antenna may generate harmonics which will affect the GNSS performance.
5.3.2. Recommended RF Connector for Antenna Installation
If RF connector is used for antenna connection, it is recommended to use the U.FL-R-SMT connector
provided by HIROSE.
Frequency range: 1559MHz ~1609MHz
Polarization: RHCP or linear
VSWR: < 2 (Typ.)
Passive antenna gain: > 0dBi
Active antenna noise figure: < 1.5dB
Active antenna gain: > 0dBi
Active antenna embedded LNA gain: < 17dB
VSWR: ≤ 2
Efficiency: > 30%
Max Input Power (W): 50
Input Impedance (Ω): 50
Cable Insertion Loss: < 1dB
(LTE B5/B8/B12/B13/B18/B19/B20/B26/B28, GSM850/EGSM900)
Cable Insertion Loss: < 1.5dB
(LTE B1/B2/B3/B4/B25/B39, DCS1800/PCS1900)
To Next Page
Loading...
Need help?
General
