To Next Page

To Previous Page

8. WEIGHING

Before start of measuring process or in case of essential change of ambient

conditions at a workstation (e.g. ambient temperature change at a workstation) the

moisture analyzer requires adjusting. The procedure of moisture analyzer

adjustment is described further in this user manual.

• Before start of measuring procedure, it is recommended to load the moisture

analyzer’s pan a few times with mass close to the max capacity,

• Check if unloaded moisture analyzer indicates “precise zero” -

and

whether measurement is stable - , if not press ESC/TARE key,

• Place weighed object on moisture analyzer’s weighing pan and read result

only on stabilization of measurement result,

• Mass indication of a load placed on moisture analyzer’s weighing pan can be

tarred for multiple times by pressing ESC/TARE key (pay attention not to

exceed maximal capacity of a moisture analyzer by applying multiple tare

function).

During times between carrying out the following measurement series do not unplug

the moisture analyzer from mains. It is recommended to switch off moisture

analyzer’s display by pressing ON/OFF key. On repeated pressing of the ON/OFF

key the moisture analyzer is ready for operation and carrying out the following

measurements.

9. MOISTURE ANALYZER MAIN PARAMETERS. ADJUSTING MOISTURE

ANALYZER OPERATION TO AMBIENT CONDITIONS AT A WORKSTATION

• Setting filtering level – AuE.

• Autozero function – Auto.

• Access to library of drying modes – Libr.

• Backlight of measurement result - bl.

• Display brightness - blbA

• “Beep” sound – reaction on pressing a key – bEEP.

RADWAG MAC Series User Manual

Questions and Answers: