7
CONSOLE FEATURES
IMPORTANT: This Console requires selection of US (acres), SI [hectares], or TU
{1,000 sq. ft.} area; SP1 (wheel drive, etc.) or SP2 (radar) speed sensor; and
C-Sd (Standard Valve) or C-FC (Fast Close Valve).
ENTER - Used only to enter data into
the Console.
CE - Use like you do the CE key on a
calculator.
Selects Off (Power Off), manual,
or fully automatic control.
Displays actual rate of application,
calibration, and function data.
CALIBRATION KEYS -- Used to enter data into the
Console to calibrate the system.
BOOM CAL -- Length of Boom. Select Boom
number by using the UP/DOWN
arrow keys.
SPEED CAL -- Determined by Speed Sensor
METER (FLOW) CAL -- Meter Calibration Number
VALVE CAL -- Valve Response Time
FLOW RATE -- Target Application Rate
FUNCTION KEYS -- Used to Display Data
DISTANCE -- Distance Traveled
SPEED -- Speed of Vehicle
TOTAL VOLUME -- Total Volume Applied
TOTAL AREA -- Total Area Applied
Console Revision can be determined by the
letter stamped in REV box on label.
Console Program can be determined by the
letter stamped in PGM box on label.
To Next Page
Loading...
Need help?
General
