Raymarine GPS Plotter User Manual

3-42 Raynav 300 GPS Plotter
2. Check the route and, in particular, that the route deviation from the
original, given in the warning box, is within navigable limits.
Managing Tracks
It is a staightforward task to set up a Current Track which is retained even
if you switch off your display unit. In addition, up to five different tracks
can be saved so that you can use them at a later date. This section explains
how to perform the following tasks:
• Save and name the Current Track.
• Name, Erase and Show a previously saved track.
Saving and Naming the Current Track
Up to five named tracks can be held in the Track List. These tracks can be
retrieved at a later date.
➤ To save and name the current track:
1. Press the
TRACK LIST soft key. The track list pop-up and associated
soft keys are displayed.
2. The next available entry on the track list is highlighted. If required,
use the trackpad to select an alternative position in the list; this can be
a blank slot, or an existing track that you no longer require.
3. Press
SAVE TRACK. The Name Track soft keys are displayed as shown
in Figure 3-44.
Figure 3-44: Name Track Soft Keys
4. To name the route press the YES soft key.
i. Use the trackpad left/right to select the character you wish to edit
and the trackpad top/bottom to change the character.
ii. Press
ENTER to finish and clear the Track List.
5. To save the unnamed track, press the
NO soft key to clear the list. The
track is saved and is listed as
TRACK NOT NAMED.
6. Press
ENTER to finish and clear the Track List.
7. To return to the Track soft key display, press
CLEAR.
8. To return to the default soft key display, press
CLEAR again.
YES NO
NAME TRACK?
D4922-1
81171_4.BOOK Page 42 Thursday, November 29, 2001 11:34 AM

Raymarine GPS Plotter Specifications

General

Brand	Raymarine
Model	GPS Plotter
Category	GPS
Language	English