28 RayPilot 650 Control Unit - Owner’s Handbook
3 Maintenance & Fault Finding
• Always report any EMC-related problems to your nearest
Raymarine dealer. We use such information to improve our
quality standards.
• In some installations, it may not be possible to prevent the
equipment from being affected by external influences. In general
this will not damage the equipment but it can lead to spurious
resetting action, or momentarily may result in faulty operation.
3.2 Servicing
WARNING:
The RayPilot 650 control unit has an electro-fluorescent panel to
provide display backlighting. The circuitry used to drive this
panel generates approximately 300 V. You must NOT operate the
unit is with its cover removed.
Servicing should only be carried out by qualified service agents or
authorized service centers.
3.3 Product support
All Raymarine products are designed to provide many years of
trouble-free operation. We also put them through comprehensive
testing and quality assurance procedures before shipping.
Raymarine products are supported by a worldwide network of
distributors and Authorized Service Representatives.
Before you consider returning the autopilot, make sure that the power
supply cable is sound and that all connections are tight and free from
corrosion. If you cannot trace or rectify the fault, contact either your
national distributor, service representative, or the Raymarine
Technical Services Call Center. Refer to the back cover or the
Worldwide Distributor List for contact details.
Always quote the product serial number, which is printed on the back
of the control unit.
81013_4.book Page 28 Wednesday, July 25, 2001 11:04 AM
To Next Page
Loading...
Need help?
General
