Raymarine SmartPilot ST6001 User Manual

Chapter 2: SmartPilot Commissioning 33
• sail boats: with the sails down, steer straight ahead (rudder centered)
and motor the boat at typical cruising speed
• if conditions are not calm, head into the wind and waves
3. When you are ready to proceed, press +1, or turn the rotary control clock-
wise.(On ST8001 & ST8002 systems, you must also then press auto)
4. The screen will then show the CLEAR TO MANEUVER message. If it is
safe to continue, press auto to start the AutoLearn maneuvers:
• the boat will start a series of zig-zag turns and the display will show
LEARNING with a number to indicate the current AutoLearn stage
• this number will increase as AutoLearn progresses
• typically, the AutoLearn will be complete within 7 to 27 steps (depending
on boat characteristics and sea conditions)
Note: If you need to cancel the AutoLearn, press the standby or disp key.
5. When the SmartPilot has finished learning, the controller will beep and will
display either LRN PASS or LRN FAIL:
• LRN PASS = AutoLearn completed successfully
• LRN FAIL = AutoLearn was not successful, so should be repeated. A fail-
ure code will also be displayed:
1 = AutoLearn has not been carried out
2 = AutoLearn failed, due to manual interruption
4 = AutoLearn failed, probably due to drive or compass failure
6. Press and hold the standby key for two seconds to store the new settings.
2 sec
D6331-2
AutoLearn successful
If you need to cancel the AutoLearn, press or
Note: If you see a
LRN FAIL message,
press disp to return to
the AUTOLEARN screen
then repeat from Step 2
After
7 to 27
steps
!
Boat completes AutoLearn
Save new settings
To:
• save AutoLearn calibration settings
• return to STANDBY mode
81273_1.book Page 33 Thursday, November 10, 2005 8:25 AM

Raymarine SmartPilot ST6001 Specifications

General

Brand	Raymarine
Model	SmartPilot ST6001
Category	Marine Equipment
Language	English