11
OPERATING the Receiver
To Play a Preset Station
Press the appropriate Preset Stations number. For stations 1,
2 or 3 press 0, then press 1, 2, or 3. For stations 4 through 30,
press the numbers directly.
Or, press CHAN UP on your remote to tune to the next preset
station or CHAN DOWN to tune to the previous preset
station.
Preset Scanning
Use the PRESET SCAN button on the receiver’s front panel to
review the preset stations stored in the tuner’s memory.
“PRESET” and the station’s location in memory appear in the
display. The tuner automatically scans all preset stations in
order, pausing at each one for approximately
5 seconds.
When the tuner reaches the station you want, press PRESET
SCAN to stop the scanning. If the scan is not interrupted, the
tuner reviews all preset stations in order, stopping at the
point where the scan began.
To Next Page
Loading...
Need help?
General
