26
Programming the Remote
You can program the remote to control most brands of
remote controllable TVs, VCRs and cable boxes. If you
have an RCA, GE or ProScan VCR, you may not need to
program the remote at all. Other manufacturer’s brands
need to be programmed.
Programming the Remote to Control
a TV
To determine whether you need to program the
remote, turn on the TV, point the remote at the TV’s
remote sensor and press TV. Then, press the POWER, or
CHAN UP or DOWN button to see if the TV responds to
the remote commands. If not, you need to program the
remote.
Follow these steps to program your remote to control
your TV:
1. Turn on the TV.
2. Look up your TV brand and code number(s) in
the code list on the next page or on the code
sheet packed with your remote.
3. Press and hold the TV button on the remote.
4. Enter the three-digit code from the code list.
5. Release the TV button, then press POWER to
see if the TV responds to the remote
commands. If not, try pressing TV
then POWER.
6. Repeat steps 3 through 5 using the next code
listed for your TV brand until the TV responds
to the remote commands.
Programming the Remote
This remote may not operate all
models of the brands shown.
If a battery is removed from the
battery compartment of the
remote control, all control key
functions will return to the
original mode.
To Next Page
Loading...
Need help?
General
