Automatic Tracking
The VCR has automatic tracking which adjusts the picture when playing back
a tape recorded on another VCR. Automatic tracking is turned on whenever a
tape is inserted or the VCR’s power is turned on.
Manual Tracking
Occasionally, you may need to manually adjust tracking on a tape recorded on
a different VCR or camcorder. The TRACKING buttons on the remote or VCR
are used when playing a tape. They have no effect during recording.
• When streaks or snow appear, press
TRACKING up or down for the best possible
picture.
• Press TRACKING up or down during stop-
action pause to reduce picture “jitter”.
• Press both TRACKING buttons at the same
time to turn automatic tracking back on.
Pro-Tect Plus™ Locking Feature
To protect your timer recordings from any unwanted changes, lock the VCR.
The buttons on the VCR and remote will not operate the VCR. Just follow the
directions below.
To Lock the VCR
1. Set up your VCR for a timer recording.
2. Insert a cassette with safety tab intact.
3. Place VCR in stop mode.
4. Press and hold POWER on the remote for at
least six seconds until LOCK appears in the
VCR's display panel.
To Unlock the VCR
Press and hold VCR1 (VCR2•LD) on the remote
until HELLO appears in the VCR’s display panel
to unlock the controls.
To Next Page
Loading...
Need help?
General
